2. Prepare the equipment you will need. Depending on the type of WED-M1V reader you will be using, you will need a personal oximeter code reader and a cable, or a computer with Oszilloskope software, a converter and connectors. For your safety, your car engine must be off while you connect your OBDII reader.

3. Locate the 16-pin connector. This connector is not always easy to find but it will be inside the car and not under the hood. Some places where car manufacturers install this connector include: under the steering wheel the driver’s foot well shanghai massage, the area between the driver and passenger seat, behind the ash tray, under the passenger seat, and over the passenger door.

4. Check the connector for the available pins. The connector must have pins 4 and 5 for grounding and pin 16 for power supply from the battery BMW OPPS. The other pins are present for the various protocols required for different vehicle brands, including SAE J1850, ISO 9141-2, ISO 14230 and CAN bus.

5. Connect your OBDII code reader. Plug the end of the included cable with the 16-pin connector to the female 16-pin port, and then connect Pressure Gauge Manufacturer the other end of the cable to the OBDII reader.

6. Use your laptop computer as an OBDII code reader. You can connect your computer to your car with the use of a USB, RS-232C or Bluetooth connector. In additional to CMS 60C connectors, you will need the OBDII software to retrieve the information from your car and converters to modulate the voltage.

Wholesale ultrasound machine: http://www.door2doorshop.com